Page 7 of 13

Re: Chassis Reinforcement

Posted: Thu Sep 16, 2010 10:07 am
by Firebass
anyway i figured it out , we make an angle at this base , its from ABS box and we will install the strut bar from the Type-R and also i will put another bar down and front at the "sciscors" :D
also i will install rear disc brakes with ABS and perfecto ^^

Re: Chassis Reinforcement

Posted: Wed Nov 03, 2010 11:05 pm
by saxophonias
Image

these bars are stock dc2. i would love to have them installed. Have you seen any around or even do we know any part numbers? Maybe from honda they aren't expensive just like the ek4 strut bar

Re: Chassis Reinforcement

Posted: Thu Nov 04, 2010 1:39 am
by BETEK
The bar at top of fuel tank is not to make the car stiffer, is just for protection wires and fuel tank cap.
The bar at trunk reinforces the chassis at dc2, the eks have the bar for trunk reinforcement outside. I mean the item after the rear bumper (number 13 at picture), it makes the same job as the bar in trank of dc2
Image
http://www.hondapartsnow.com/Page_Produ ... ame=Bumper

HondaNickx has one from ek9 but is the lightweight edition of rear beam
Image
viewtopic.php?f=3&t=133&start=70

Re: Chassis Reinforcement

Posted: Thu Nov 04, 2010 1:48 am
by BETEK
The other option is to put trailer hitch, it makes the same job and you can have trailer ;) :mrgreen:

Re: Chassis Reinforcement

Posted: Thu Nov 11, 2010 9:48 pm
by Dodo Bizar
Hehehehehe :lol:

Re: Chassis Reinforcement

Posted: Sat Nov 13, 2010 1:43 am
by saxophonias
Image
From Nick's post,
the bars cost 100 and 167 pounds respectively. they surely give strength to the chassis
http://www.hondaoriginalparts.com/honda ... k_03=19788

Re: Chassis Reinforcement

Posted: Sat Nov 13, 2010 3:16 am
by BETEK
The number 3 bar is from the rear subframe.
I want to put one from ek9 (dc2 doesn't fit)
Aslo the number 1 bar doesn't fit on ek civics (LHD) with abs.
The abs fuse box obstructs the bar :(
As for the number 4 bar doesn't fit as I know.
But we can swap a rear bumper beam from 99-00 civics. Moreover we can swap from 99-00 civic the front bumper beam for the front axle :)

Re: Chassis Reinforcement

Posted: Sun Nov 14, 2010 2:29 am
by BETEK
Rear beam civic ek
Image

Rear civic ek9 bar
Image

Front beam
Image

Re: Chassis Reinforcement

Posted: Mon Nov 15, 2010 3:24 am
by saxophonias
man i a bit dubious whether the impact bars offer any rigidity, good for cornering. Apart from protection on crashes
the way and the point they embrace the chassis and finally the extra weight especially in front don't know if they are of any good.

Re: Chassis Reinforcement

Posted: Mon Nov 15, 2010 1:14 pm
by BETEK
Yes the weight is an issue but I think the bars and beams are making job
Here is the front bar of ek9
Image