Page 1 of 2

Error Scan

Posted: Wed Aug 12, 2009 5:31 am
by Law_
Hi :) i've made a scan for my ECU errors and there were three. i've already disconnected battery for 20min but the errors are still there
They appear with the ABS light, not the SRS, not the engine light.
They are the

16 - Fuel Injector System
defective circuit or unplugged / defective fuel injector

54 - CKF Sensor (Crankshaft Speed Fluctuation)
defective circuit or unplugged / defective sensor

61 - Oxygen Sensor, Heated - Sensor 1 (Primary)
high voltage, low voltage, or slow response.

The car seems fine. It does 6.5 L / 100 km. It runs vert nice, frequent 7000rpm just when hot obviously but seems ok. Top Speed @ 4th Gear easily achieved. Dont know what to think about that...

Re: Error Scan

Posted: Wed Aug 12, 2009 5:33 am
by Law_
BTW... for anyone wanting the codes here they are.

http://hybrid.honda-perf.org/tech/codes.html

Re: Error Scan

Posted: Wed Aug 12, 2009 8:08 am
by saxophonias
Weird. Do you have a tester or did you count the blinking of the light?

Re: Error Scan

Posted: Wed Aug 12, 2009 9:59 pm
by Law_
Just the blinks...

Re: Error Scan

Posted: Tue Aug 18, 2009 9:36 pm
by Dodo Bizar
Ehr weird, what is you setup? No CKF sensor anymore? The code 16 is really weird and should not be unless serious something wrong in the injector department. Oxigen sensor code 61, also new for me... is it the code you get with OBD2b when having no more catalyc converter or something (just throwing some guesses now).

Re: Error Scan

Posted: Tue Aug 18, 2009 10:43 pm
by Law_
electronics and the rest is stock... no setup already. it is weird for me. the light that blinks is the ABS one. is that suppose to happen?

Re: Error Scan

Posted: Wed Aug 19, 2009 5:25 pm
by Dodo Bizar
Ehm no, your CEL or MIL light should flash... the engine error check light which comes on a sec before you start the car.

The ABS light should mean AB doesS errors... I think.

Re: Error Scan

Posted: Wed Aug 19, 2009 8:10 pm
by saxophonias
A friend's d15z had problems with his abs light coming on. Have you checked if the abs is working right?

Re: Error Scan

Posted: Thu Aug 20, 2009 6:47 pm
by Law_
The ABS is working right but i had some problems trying to pull the handbrake making handbrake turns. the ABS light comes on when the tail slips and does not turn off... Just when i restart the car...
i've disconnected the battery for 20min or so and did the right procedure, letting the car warming without touching the pedals until the cooling fan starts 2 times. the erros did not erase.
My CEL light or SRS light did not blink, so guess is an ABS error?
Thank you all

Re: Error Scan

Posted: Thu Aug 20, 2009 10:03 pm
by Dodo Bizar
Hahaha, ABS is supposed to throw an error when the rear blocks. During dyno sessions with ABS cars the light always comes on. But after normal driving a while (and a restart) it should not come back at all. Unless another wheel lock happens at the aft.