Page 1 of 1
Green C131 and blue service connector
Posted: Tue May 10, 2011 6:18 pm
by ilya
hi mans, could u tell me what is it?
i know, it is P3Y.
2 gray connector at the bottom, it refers to driving.
--- 2 connectors go together in a green rubber.
3-pole blue, it's K-Line, yes?
2 pin blue, is a service connector, yes?
---
What is the green connector on among the pictures??
Re: Green and blue connector
Posted: Tue May 10, 2011 7:14 pm
by BETEK
"On later systems a 2-pin service check
connector (SCS) is jumpered and the
codes are flashed on the dashboard MIL.
Image 3-1 shows the 2-pin SCS (marked
by white arrow). This connector is typically located behind the dash at the
lower right corner.
Note that there is another connector
right beside the 2-pin SCS, a 3-pin connecter. This is a data link connector
(DLC) and is used by a scan tool to retrieve serial data from the ECM. It is
easy to confuse this connector for the
SCS. The DLC is a 3-pin connector, but
sometimes only has two wires in the
connector. Always jump the wires that
are in the connecter with only 2 cavities.
All the 2-pin SCSs can be jumpered by using a wire, and the later systems have a
SCS tool available from Honda. The Honda SCS tool that works on all late model
systems is part # 07PAZ-0010100 and retails for $3.75 (shown in Image 3-2). "
from: http://www.ej9.ru/civic/book/chpt_03.pdf
page 4 --> 3.4.2 Read at MIL / 2-Pin Service Check Connector (SCS)
Re: Green and blue connector
Posted: Tue May 10, 2011 7:18 pm
by BETEK
The green connector (C131) is for connecting main wire harness to engine wire harness
Re: Green and blue connector
Posted: Tue May 10, 2011 7:27 pm
by ilya
lol....
tnx man,of course i have all documents........ i'm litle lazy, sorry )
Re: Green C131 and blue service connector
Posted: Tue May 10, 2011 8:28 pm
by BETEK
welldone for your site, you did good job
Re: Green C131 and blue service connector
Posted: Tue May 10, 2011 10:28 pm
by ilya
tnx and welcome with "translate Rus->Eng"
