www.dodo-upgrades.nl

I have used your mini-me guide to do a 1.4 mini me and everything went
well except that my injectors won't spray.

Can someone help me?

THX
J.D.

You mean they don't work at all? Maybe something went wrong with the obd plugs?

Welcome to the DU, please introduce yourself in the newbies section as well.

Getting petrol should never be a problem. Do you have fuel pressure?

Check for all wires if they are hooked up correctly, shorts etc.

I have found the problem.
The car used to run on LPG wen they removed
it they didin't remove the cables that goes to the
injectors. so the yel/bl cables was cut for the LPG switch.

Now the runs but not so good. The 1 cilinder spark but
it look like it doesn't. I dont know if the timming is a little
of or if its the dizzy. And when i drive the light goes up and
down and i think hear the ECU peeping at the same when
the lights go up and down.

Can someone help me pls......

I got a feeling some electronics are still not ok... double check all the wiring. Sounds like a bit of short-circuiting somewhere. ECU should not make sound at all...

Also, putting a P28 directly on D14 mini-me can get bad performance. I had it with my first try. Fuel at low revs was way too much. High revs was ok... too rich mixture might cause one spark to miss fire and the others barely manage to get a descent spark. Plans on tuning the ECU? Wideband lambda can really help here. Contact CRX2 if you need a good eCtune tuner...

I didn.t connect the d16z6 lambda yet, is that the problem?
I couldn't take it off. now i'm going to replace the whole
exhaust manifold.

Neh, broken lambda would still make the car run. It would run terrible with rich mixture, but it would run.

I found that the problem is the altinator i have to replace it with a new one.

Thx guys anyway

maybe its just the alternator fuse ... happened to me....
There is a service callback for this reason....(some wires under the intake manfold... )

Where is this fuse, in the engine bay?