Page 1 of 2
throttle cable (for IM swapping on D14)
Posted: Sat May 01, 2010 1:20 pm
by lelouchvi
Hi all,
I am going to a IM swap with my D14, at the moment I am short of the throttle cable, I can get hold of one which is a B16b, would it fit? I am going to use the D14 TB but with a D16 pulley, is that ok? Please correct me if I am wrong...
Re: throttle cable
Posted: Sat May 01, 2010 7:14 pm
by marty40
the d14 one should fit if i remeber correctly. im still using the standard d14 cable. the only thing is its a bit longer than a d16 but still fits. i think...
Re: throttle cable
Posted: Sun May 02, 2010 2:56 pm
by lelouchvi
aiii , I see. Thanks for that, clear things up a bit. but I do need swap the pulley right?
Re: throttle cable
Posted: Sun May 02, 2010 3:49 pm
by ilya
I have not changed my pulley. D14 cable suits, it is very long, it can be everywhere, but not beautiful!
that's why I used the cable from the CRX was a little shorter. approached me and just right.
PS. remind me have automatic gearbox, and PULLEY bit different.
Re: throttle cable
Posted: Sun May 02, 2010 9:08 pm
by lelouchvi
I have a manual tho, but thanks
Re: throttle cable
Posted: Sun May 02, 2010 9:23 pm
by Law_
You do have to change pulley for a pulley from an side flow IM. you can read about that on IM SWAP posts from dodo =)
Re: throttle cable
Posted: Mon May 03, 2010 1:03 am
by lelouchvi
Thanks, Law. I going to use the pulley on the D16Z6 and put it on the D14 TB now. Hopefully things will go well during the swap. Do you guys have any difficulties in swapping? Dodo mention that he didn't run the coolant through the IM? should I? is it good or bad?
Re: throttle cable
Posted: Mon May 03, 2010 2:05 am
by Law_
i didnt either, you have a review on my "newbie corner". Difficulties... yes, at least one. My idle was baaaad ! erratic : RACV didnt work well maybe it is dirt or something, and i shut it off afterall. If you are not installing IACV at the moment, please shut the IACV hole very very well. If you are using D15Z6, remove EGR mechanism and cover it very well too.
Cheers
Re: throttle cable
Posted: Mon May 03, 2010 2:49 am
by lelouchvi
I do have myIACV on my D16Z6 at the moment. I should just leave it there unplug right?
The RACV is on the D14 TB right? if so just unplug and replug after installing?
Re: throttle cable
Posted: Mon May 03, 2010 2:17 pm
by Law_
sorry i didnt understood right.
you can use RACV (on D14 TB) but mine didnt work well after IM swap, maybe that was from the new installation position. After OBD1 swap you can use IACV although i know OBD2 cars with IACV, but i've tried before OBD1 swap and it cannot be done. But yes, just unplug sensors and reinstall them in the end, reseting the car also. You might be lucky and your RACV might work well