What D16Z6 parts can I salvage? (for swapping IM to D14)

[ilya]

i think EK3 have OBD2 connectors.

[IMGREENMAN]

from dodo guide on on the main page

The incredible easy and no so expensive method:
Nowadays some very large shortcuts can be made by throwing away the original EJ9 engine loom. Instead search for an EK3 OBD2a engine loom (Civic VTEC-E 96-98). This looms fits on our engine and interior plugs, comes with VTEC equipped and after market conversion harnesses can be bought for it. So the section called ‘conversion harness’ till ‘RACV to IACV’ can all be skipped as far as the electrical wiring goes. As a bonus you could use D15B7 dizzy or even go for the EK3 dizzy. The last will fit straight away, but the first one can be connected with a dizzy conversion harness, readily available these days. That is awfully easy compared to the rest of my write-up.

[IMGREENMAN]

or am i mis reading it?

[ilya]

i don't know.... i just cut my EJ9 P3Y Plugs and add OBD1 PLUG'S (connectors).

[IMGREENMAN]

did you then add wires to the obd1 plugs for vtec

[ilya]

yes. 1 wire to vtec solenoid and 1 to VTS (oil pressure vtec sensor)