hello
i have a face lift ej9 d14z2
now i swapped the d15z6 from a ek3 pre face lift
bur now i dont have a rmp gauge km gauge fuel and water also if i put it in reverse the lights dont work
i was looking at the kabels and i see that the socket is te same but the kabels are put in difrend
some have pin out.... link for a site ....can you buy harnas....
ej9 interieur problems
-
saxophonias
- Posts: 2592
- Joined: Fri Jul 03, 2009 6:03 am
Re: ej9 interieur problems
it seems you have messed with the wiring. Do you have the pin outs and the electic diagram of the car?
Re: ej9 interieur problems
its the obda2 i just see on your pin outs
but listing the car is complete stock ej9 with d14z2 wiring inside en the engine and loom are d15z6
i didin't cut anything all is just connected
but now i see that the connector off interieur are the same but the cables are not
if you want i make foto and than you can see
car is honda civic ej9 d14z2
engine d15z6 and engine loom d15z6 with the oem ecu p2y
i removed the immobileizer off the p2y then my car start's but my rmp km fuel and water gauge dont word
my reverse dont work vtec dont work
but listing the car is complete stock ej9 with d14z2 wiring inside en the engine and loom are d15z6
i didin't cut anything all is just connected
but now i see that the connector off interieur are the same but the cables are not
if you want i make foto and than you can see
car is honda civic ej9 d14z2
engine d15z6 and engine loom d15z6 with the oem ecu p2y
i removed the immobileizer off the p2y then my car start's but my rmp km fuel and water gauge dont word
my reverse dont work vtec dont work