240 cc obd2a injectors

baz · Post by **baz** » Sat Mar 13, 2010 3:42 pm

I've heard that 240cc injectors from a D16Z6 dont fit on your standard clips from your d14a3.

Is that right and how to solve?

BETEK · Post by **BETEK** » Sat Mar 13, 2010 5:35 pm

Yes, they do not fit.

Law_ · Post by **Law_** » Sun Mar 14, 2010 5:09 pm

They dont? Didnt knew...

baz · Post by **baz** » Sun Mar 14, 2010 7:09 pm

Ok clear, are does anyone know the solutions for that problem?

BETEK · Post by **BETEK** » Sun Mar 14, 2010 8:21 pm

The solution is to cut your d14a3 clips and connect the D16z6 one.

BETEK · Post by **BETEK** » Sun Mar 14, 2010 8:22 pm

The alternative way is to put the injectors from d16y8, they are direct bolt on to the d14a3 clips

Law_ · Post by **Law_** » Sun Mar 14, 2010 8:32 pm

and d14a4 also right? cheers

baz · Post by **baz** » Sun Mar 14, 2010 9:18 pm

BETEK wrote:The solution is to cut your d14a3 clips and connect the D16z6 one.

Check, pritty much obvious. Maybe i will run the engine with 190cc and later 240. Havnt figure it out yet..

BETEK · Post by **BETEK** » Sun Mar 14, 2010 10:09 pm

Law_ wrote:and d14a4 also right? cheers

I supose yes because both d14a3-4 are obd2

ditto · Post by **ditto** » Tue Mar 16, 2010 12:16 am

cool gonna nick the y8 injectors tomorrow at scrap yard

... but are they gonna give any differences? if i use z6 manifold can i still use y8 injectors?

thanks.