240 cc obd2a injectors

[Dodo Bizar]

The difference in clips is the difference between the OBD1 and OBD2 injectors. Functioning is the same.

[saxophonias]

Here is a very good picture

you can make OBD1 injectors fit into an OBD2 plug by pulling out the blue insert as seen here:

]

http://www.honda-tech.com/showthread.ph ... 711&page=5

Is it accurate boys?

[cad civic mechanic]

Here is a very good picture

you can make OBD1 injectors fit into an OBD2 plug by pulling out the blue insert as seen here:

]

http://www.honda-tech.com/showthread.ph ... 711&page=5

Is it accurate boys?

Can be done but connection is bad. I asked Dodo about this one and thats what he said. Each to there own way i suppose, but hey guys why compromise, just do it right

[BETEK]

Furthermore the splashing water from wet road or the damp will cause bad connection.
Better is to go with obd1 clips.

[ilya]

saxophonias, man!))) I found this picture yesterday, and wanted to add) fast!)

Incidentally an interesting idea, I have not thought about it. would have to look OBD1 wiring and cut the injector.

Can be done but connection is bad. I asked Dodo about this one and thats what he said. Each to there own way i suppose, but hey guys why compromise, just do it right

[Dodo Bizar]

I tried the above picture once myself... did not like the fit, felt flimsy.

[jangz]

I asked about this a little while ago actually. I have the stock 240cc injectors off a D16z6 and as you all know it wouldn't fit on to my D14z2.

So I approached the ghetto way, as I was short on money to get new injectors that actually fitted without messing around with the wires and plugs etc.

So I had the 8 wires cut and soldered. My friend is qualified in (electronic engineering) and did it in a way where it was very neat and tidy and shrink wrapped the wire so nothing is lose or exposed and ran perfect and feels solid.

[Dodo Bizar]

Actually my B16B has the same, but for the opposite reason, original OBD1 loom with OBD2 plugs soldered on it . But good soldering and heatwrapping is the best way if you must, holds for years. Good work!

[ilya]

about connection problem, i solve it
u have non connector, and u dont want solder injectors?

yestarday i connect my jets with WaveGenerator, for searching frenquence.

i buy "small sound auto jack", solder it, and connect IT with JETS! it's hardly connect.
red silicon, u must push down.


try it

[ilya]

what happens if I replace 190cc by 240cc at ECU OBD2A 90BHP?